Control surface linkage
Surface that moves up and down on each side of neutral (ailerons, elevator, rudder).
Servo horn or Control horn: the part to make, the other being already chosen. “Check”: both parts are known, and the calculator gives the throw obtained.
A: arm length, from the servo shaft to the linkage hole.
B: servo horn angle at neutral, from square to the servo, positive toward the control surface; 0 = straight arm.
C: height of the linkage hole above the hinge axis.
D: offset of the control horn hole relative to the hinge, positive forward (servo side); 0 if the hole is in line with the hinge.
Servo horn known: control horn hole height computed.
E: from the servo shaft to the hinge, measured at the control horn.
F: height of the servo shaft relative to the hinge; 0 if both are aligned.
G: spanwise offset between the servo and the control horn.
G: spanwise offset between the servo horn and the control horn, positive when the control horn is closer to the wing (or stab) tip; 0 if the pushrod follows the fuselage axis.
H: hinge angle seen from above. 0 for a straight hinge, positive if it sweeps back, negative if it sweeps forward.
I: servo travel each way, often close to ±45° at 100% end point. The percentage next to I is the radio end point at which I was measured.
J: throw you want each way, not the total throw. Measured square to the hinge.
I: total servo travel, from one end to the other, often close to 90° at 100% end point. The percentage next to I is the radio end point at which I was measured.
J: total surface throw, from start to end. Measured square to the hinge.
Start angle: position of the surface at the start; 0° = in line with the airfoil, negative = slightly upwards.
DifferentialDifferent up and down throws.Off
With 30%, the small side is 70% of the large one; J remains the target ▲ throw.
Same throw on both sidesWhat makes up the gap between ▲ and ▼.By the control horn
If the two sides differ, the control horn hole is offset (dimension D).
Result
Build
Dimensioned drawing of each part, as a 3D model or a 1:1 plan to print.
Dimension origin: hinge axis. Adjust C and D if the horn base is set back from it.
Radio setup
End points, D/R and expo to set in the radio.
The linkage is not linear: it already acts like expo (−6%, sharper around neutral). Radio expo adds to it: the “to set” values allow for this, for each rate and each direction.
In the radio, servo travel = D/R × end point. High rate: D/R at 100%, the ▲ / ▼ end points carry the target throw (and make up any gap left between ▲ and ▼).
Here, positive expo softens the centre. Some radios use the opposite sign: check at the stick that the centre does get softer.